Print Page - Crank in rd400 Does this look right

Title: Crank in rd400 Does this look right
Post by: rd400greenhorn on March 02, 2019, 02:52:59 PM

Hi guys
Iam finally in the proces of fitting the crank, the pins fit now
Stupid question but everything is a First

Does this look right? Seals Are located correct, right way?

Cheers :patriot:

Title: Re: Crank in rd400 Does this look right
Post by: Striker1423 on March 02, 2019, 02:57:25 PM

Springs always face the outside. So, I'd say yes. :)

Also, make sure to put a little 2 stroke oil on the lips of the seals.

Title: Re: Crank in rd400 Does this look right
Post by: ~JM~ on March 02, 2019, 09:26:07 PM

Are the steel bearing alignment rings in place? Can't tell from the pictures.

Title: Re: Crank in rd400 Does this look right
Post by: rd400greenhorn on March 03, 2019, 06:31:32 AM

The two cases Are together and done 😁 Hopefully Iam doing it right :vroom:

2 STROKE WORLD .net

The 2-Stroke Garage => Turning Wrenches => Topic started by: rd400greenhorn on March 02, 2019, 02:52:59 PM