Messages

Does anyone know if the RD400 swing arm is the same length as RD250/RD350/R5 etc.

Where can I get a race seat for my RD , now that Airtech isnt around ?

Has anyone used the Toomey CDI box on thier RZ? Is it plug and play ? Does it have a wire for an electronic tach ?....thanks

I have 2 of them , the tank panels are white with red pin striping. I believe the chrome tank panels were for the low pipe version

Does it come out easy ? , or does it put up a fight ?

I want to use a banjo bolt on my front caliper. How do you remove the fitting which is already in the caliper that accepts the hard brake line ??

I have heard a few negative reports about those harnesses

Does anyone have or know where I can find a "minimal" wiring harness for my RD400? . I want lights etc , but no horn , turn signals , gauge lights etc. There used to be a company who would make them to oder , but I can't remember thier name

The RD350N , didn't have a fairing , the gauges are correct

Does an RD400 motor fit in an R5 frame ?.I am think about the RD400 rubber mounts

still have ?

Also now , VT does not accept your bill of sale. So if you are applying even for just a frame they take a percentage of the KBB book for a "fair" condition RD. KBB values are off the charts. i just had my application returned , along with a copy of the KBB values

Is it possible to powder  coat expansion chambers ? , or do the header pipes get too hot ?

it seems the "easiest" would be to try one of the new reproduction aluminum calipers. I am not looking for mega braking powere , just want it to work good. my original iron caliper is binding , so rathere than mess around with it , I want to try something different

Has anyone tried one of the reproduction calipers from Economy Cycle ??