Messages

IM not having any luck loading pictures from my phone or computer , If anyone wants  to see pictures of the carbs text me and I can send that way. 702-858-9177

MY pictures did not load .????

Venturi dividers will provide better roll on performance stronger all Throttle openings including mid-range less light switch

Prety much available most any time. Im in Utah MT time


Rich

Give me a call 702-858-9177 Check out my web site richstaylordporting.com  WE can have a counselng session

Rich

K&N filters are junk , they pass as much dirt as the do air. Use Uni filters

What care are you thinking of putting round slides on? Back in the 1970s I thought about putting eight 44mm on a small block chevy. Never did it though , I just stuck with a tunnel ram and two 600cfm hollys. The Mikuni's would work better than four webers since each carb could be calibrated for each cylinder rather than done in pairs by changing air bleeds to meet each cylinders needs . Plus a manifold with a plenum works better anyway , with a broader power band.

Rich

Question? If you are building a flat tracker why do you want such small 22mm carbs? Anyway a VM round slide is a great choice , when modified wit a  UFO a round slide will out flow a flat slide up to 15/16 throttle. And if its bored out most of the slide eddy will be eliminatd for even better flow, also the air bleed bosses can be stream lined at the opening in the rear. In the end you have a awesome sleeper carb. And I can fabricate venturi divider in either round or flat slide carbs , that make for a much more linear power delivery. You can give me a call if you like and we can talk. Check out my web site 

Richstaylordporting.com

702-858-9177

Red Line ! Thats all I have to say

Just know that the needle wont effect WOT

Sounds like it could be a lean spot . Is it at a steady throttle position , and csn you roll past that spot ?

common on snow machines , two work better though

Advance sleeve I also recommend , I had a porting job and reed conversion for a Bultaco flat tracker , the built a  aluminum sleeve for it then I did the porting then had it nicasil plated then dressed up the ports after . Advance does a good sleeve job

Rich

Hi ! Just inviting yall to check out my web site Richstaylordporting  maybe I can be of service to some of you vintage to modern porting and carb mods

Rich

that was a great run , sounds great . I especially liked the prayer in the beginning and the music. I love when believers do great things . We should talk sometime .

Rich (Richs Taylord Porting ) 702-858-9177