Messages

Oh and yes I'd love to install an electronic unit but money is tight right now. Unless there's any body out there that has a cheap one. Haha

Well I tried the condenser thing and no luck. The fucking light still stays on. I changed condenser and points with the plate and I still get the same results. One thing though it seems to be doing it on the left side only the right side is working fine. I think it might be the actual point itself, because when I start to loosen the mounting screw the light goes out. Once again like the points aren't closing all the way. Go figure. Or maybe I have to bend the point plate a little to get it to close right. I don't know

Something so simple can be so frustrating. I will try that as soon as I get home from work. I'll let you know the out come. Thank you gentlemen.

Hello Guys,

       I'm new to this forum and I am stumped on my problem and it is. When I'm adjusting the points I have a test light up ground to ground and the hot lead to the point thats getting ready to fire. So the light comes on when the points open and the light goes out when they close. My issue is the light is staying on the the whole time its like the points aren't closing all the way. I have changed points and condensers but the problem keeps happening. Any help would be a life saver. Great web site by the way I just found it and have picked up some great info.