Messages

Didn't turn out half bad. Just need to make one adjustment to them. Instead of 1.XXXX when I was offsetting the exhaust mount hole, I 0.XXXX. It's off an inch. They entirely replace the factory steel bracket, but will retain the factory exhaust mounting location, will work with the stock brake line as well. Going to use a pressure activated banjo bolt brake light switch to retain the light. Didn't turn out half bad for first pass at them. I've been building 250/350 rear sets for right about a decade, figured it was time to venture into the 400 as well.

Those are lovely; do you have a website? If not, how much are those beauties?

Drum brake set
https://slipstreamcycle.com/shop/ols/products/yamaha-r5-rd250-rd350-rear-sets

Disc brake sets
https://slipstreamcycle.com/shop/ols/products/yamaha-rd-rearsets
https://slipstreamcycle.com/shop/ols/products/yamaha-rd250-r5-rd350-rear-sets-for-disc-rear-brake-conversion

nice, ive seen a few of those (drum version) around. 

There's a few of them floating around out there. Never imagined I'd sell as many of them as I have over the years.

After round about a half decade of people asking for them, I finally got around to building some.

Guess it's been a while since I have been on here. Had to re-register my username.

Yeah, been chugging along for going on 12 years this fall.

After round about a half decade of people asking for them, I finally got around to building some.

Guess it's been a while since I have been on here. Had to re-register my username.