Messages

Hello
I tried to split the case on what I believe is a late model 1974 rd350.
I didn't realize this spacer was behind the clutch and I broke it. My other 74 doesn't have this. Any idea what it is called?
Thank you!

Where is this seal located? I can not find it in my shop manual.
Thanks much

Awesome thanks for the replies!!

I will open them and inspect. What are viton tips?  Is that something that hvc carries?

I should have mentioned that both carbs are completely clean.

I have 2 RD350s, a 73 and 74. One is pre-mix, the other autolube. Both were restored and run well. A few months ago both began to flood on the choke side carburetor as soon as fuel valve was opened, flooding that side of the engine.  A few gentle taps on bowl will usually get floats buoyant but what a pain! Does anyone have this problem or know what's going on?

Your email went to my spam. I wrote you back... if you do not get it check spam!

What kind of shape are they in? If you can, email me rickdecollo@rocketmail.com and let me know how much you would like for them.

Thanks for looking. If you happen to find another and would like to sell just reply here and I'll get in touch with you.

Awesome let me know!!

Thanks for the reply. My other bike runs ok but this one has some issues and I would
Like new needles. Where could I find some used parts? I would think these would be everywhere

Hello
I've got 3 rd350s, 2-'74s and a 73. All but one bike has y30 needle jets. I'm assuming these are aftermarket... I believe I bought from hvc. Is there any difference between these and a stock 5i4 needle? Someone told me not to use aftermarket needles but I can not locate the 5i4 needle. Does anybody have any input on this?
Thanks much!!