News:

Mat Oxley 1986 IOM TT


click above to read more about Mat.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - rodneya

#16
General Chatter / Re: Oops LOL
February 09, 2024, 10:26:35 AM
At least it came off in 1 piece.
The tank looks pretty sad under all that filler though.
#17
General Chatter / Shiny GT750
February 06, 2024, 12:22:25 PM
Saw this on facebook. Its had a lot of work put into itwab.jpg
#18
And its gone. Didnt take very long at all.
#19
No evidence other than your word, and both the shipping co and paypal ruled against you seems a but sus.

You cant buy a significantly cheaper product from what is most likely a one man show in a foreign country and expect the same customer service from a large US based company charging top dollar.
Just my opinion.
#20
Something sketchy with those rear shock top mounts
#21
General Chatter / Re: Toomey RZ350 ignition
January 28, 2024, 10:12:38 PM
If I remember right, he uses the Ignitech CDI with all the correct connectors to make it plug and play.
It does have a tack takeoff according to the manual you can download using the link.
https://ignitech.cz/en/vyrobky/dccdip2_race/dccdip2_race.htm
#22
General Chatter / Re: rd webco heads made in India
January 28, 2024, 01:05:05 AM
I've seen posts on facebook from people who have bought them commenting that they look like quality workmanship.
#23
Did you get the dents out of the silencers?
#25
General Chatter / Re: Toomey pipes available
January 22, 2024, 10:42:17 PM
The original toomeys were sold by his brother. These are supposed to be the same performance wise
#26
General Chatter / Toomey pipes available
January 22, 2024, 01:51:18 PM
etd.jpg
#27
General Chatter / Re: THE HI-JACK THREAD
January 16, 2024, 12:58:15 PM
s.jpg

Not sure what motor its built for, but she is pretty
#28
Turning Wrenches / Re: blown main fuse
January 13, 2024, 10:57:35 AM
The wires from the stator where they run under the Vape back plate can rub through and short from vibration
#29
Turning Wrenches / Re: blown main fuse
January 11, 2024, 06:39:39 PM
Testing procedure
https://www.powerdynamo.biz/eng/kb/values.htm

You can replace the relay with 4 pin one for auxiliary lights or similar. Lots of you tube vids on checking relays.

Did you locktite all screws in the vape when installing? They tend to rattle loose and cause chaos. Also check wires from vape through the case.
#30
Turning Wrenches / Re: RD350 wheels
January 09, 2024, 11:46:14 AM
If i remember right, Mikes xs has a good selection