Recent Posts

Pages: 1 2 3 [4] 5 6 ... 10
31
Turning Wrenches / Re: TM32 conversion
« Last post by Kawtriplefreak on February 26, 2021, 02:51:19 PM »


Fed the cows and spent a few minutes on the RD. All back together. Air filters and tank installed. This going to work shit is interfering with my wrenching/ jetting time. I hope to be able to do an initial run up and down the road tomorrow after chores on the farm and before work. Surprisingly I can reach both enrichener knobs without too much grief.
32
General Chatter / Re: Case & Cover Bolts
« Last post by Milan on February 26, 2021, 10:43:14 AM »
OK.

Verdict is in.
They stay Stainless.

Whole set was only $25.
I could always order another set, paint, & then see how it looks.
If there was an Inkling

33
General Chatter / Re: Case & Cover Bolts
« Last post by AAAltered on February 26, 2021, 10:38:53 AM »
I prefer shiny, here’s what you could expect...

34
General Chatter / Re: Case & Cover Bolts
« Last post by m in sc on February 26, 2021, 10:13:43 AM »
yeah, id leave them as well.  :twocents:
35
General Chatter / Re: Case & Cover Bolts
« Last post by paul1478 on February 26, 2021, 07:43:35 AM »
Leave them, they look good that way in my opinion.
36
eBay/Craigslist watch / Re: Torque Engineering chambers for RD 350
« Last post by 2steve on February 25, 2021, 10:38:43 PM »
They might be loud but not at all obnoxious and a REALLY good, deep sound.
37
General Chatter / Re: What did you do to your 2T today?
« Last post by Kawtriplefreak on February 25, 2021, 09:48:30 PM »
Re-arranged the oil tank vent line so I could fight the air filters easier on the TM conversion on the RD and had to quit to get ready for work. I am about 20 minutes from the 1st road test beginning of the jetting runs.
38
General Chatter / Re: What did you do to your 2T today?
« Last post by m in sc on February 25, 2021, 09:39:56 PM »
rode it to work.
39
eBay/Craigslist watch / Re: Torque Engineering chambers for RD 350
« Last post by patastinky on February 25, 2021, 08:07:03 PM »
Ouch that seat :bang:
40
General Chatter / Re: Case & Cover Bolts
« Last post by klaird on February 25, 2021, 07:39:53 PM »
I polished mine instead of trying to paint them.
Pages: 1 2 3 [4] 5 6 ... 10