RD 350: Torque Specs for Rear Axle Nut and Rear Sprocket bolts?

[MRDRcycle]

Does anyone know the torque specs for the rear axle nut and rear sprocket bolts? The rear axle nut is 20mm and rear sprocket bolts are 17mm. The only info I have is this chart I downloaded from the RD 350 manual. Just wanted to be sure before tightening them.

Thanks!

[Jspooner]

I don't know what they should be but you go by the thread size, not the head size.

[sav0r]

I don't know what they should be but you go by the thread size, not the head size.

This!

Also bump your specs down some if you use anti-seize. About 20% less is good.

[Hawaii-Mike]

I looked in the RD400C manual (closest match I can find to RD350). 

Rear axle torque range is 87-130 foot-pounds.

Front sprocket 36-58 foot-pounds.

I didn't find the rear sprocket bolt torques and won't make a guess, except that the numbers will be much lower than the two posted above for the axle and front (transmission side) sprocket.

[MRDRcycle]

Thanks man! Illl keep them on the low side of those numbers and hope for the best. I ordered a manual but couldn't find anything either.