Messages

can we do Dave F mod  only on RD VM28 round slides? can this mod be done of a VM28SS flat slide carbs from a RG250 ?

Anyone here using VM28SS flat slide carbs from a RG250 on a RD350 ?

can we really check the health of the ignition system by one of Motion Pro Ignition System Testers ? 

Primary ratio RD350/400/LC/RZ  66/21  2.869....its 66/23 right ?

will do a bit of research, thanks so much

Race Tech Gold Valve Fork Emulators or Fork Caps with Preload Adjusters , which one I should try ?

thank you all for the valuable inputs

Like to understand whether the speedometer gear unit on the front hub of RD350.s are common for miles p/hr and km/hr bikes ?

I feel if the gasses can pass freely then it will improve performance and engine life. If lack of holes are preventing the gasses from passing freely it is not good for the engine. It may result in overheating etc... normally such situations are rare

Thank you

looking for R5 or RD250 front hub. Is it same as XS400 and RD200 ? If so any particular year i should be looking at

its an Indian CDI ignition kit similar to the Chinnoy ignition kit for RD. Has a pulsar coil on the stator which triggers the spark. Similar to the vintage Suzuki 2T igny derived 

2 single output coils or one dual output coil (banshee) is preferable ?

Thank you
Any good universal coil suggestions

For a CDI ignition can we use an HT coil from any CDI bike ? or do we need to check something ?

RX/RD-RDLC-Banshee, biggest on the right