Can anyone here that might of put an rd engine into a 250 ninja give me a close height dimension of the kaw motor? Contemplating a minibike swap. Thanks
i mean, i did it. the ninja motor is about 6" taller than an rd motor. its been a while but thats what i remember.
i did it, but i put a suzuki gt250 engine in - or rather a gt350 engine with 64mm liners. had to build a cradle for it, as the ninja engine is attached top front and lower rear. but it was easy enough :cool:
cheers, gil.
p.s. photo shows no bodywork or ramair covers.
without her clothes on:
(https://i.postimg.cc/x8s2RBRh/hamkobgt350.jpg) (https://postimages.org/)
ample room Just for grins n giggles stuck a set of cases and topend in a 02 ninja 250.
Thanks, just thinking of using the ninja motor in a big tired minibike bike.
Very nice work on that installation! :thumbs: :thumbs: :thumbs: it really looks nice.
Quote from: Gil Gallad on September 25, 2022, 01:56:40 PM
i did it, but i put a suzuki gt250 engine in - or rather a gt350 engine with 64mm liners. had to build a cradle for it, as the ninja engine is attached top front and lower rear. but it was easy enough :cool:
cheers, gil.
p.s. photo shows no bodywork or ramair covers.
without her clothes on:
(https://i.postimg.cc/x8s2RBRh/hamkobgt350.jpg) (https://postimages.org/)
Nice job, it looks like it came that way from the factory.