Messages

i don't see them on ec or yambits, but HVC seems to have them. i would go this way:

https://hvccycle.net/yamaha-r5-ds7-intake-manifold-carb-joint-278-13555-00-00/

1st gen HVC pipes (or i was told so) circa... 2010 ish or earlier?

yes will swap.. -however- there is a -slight- differences in air jet size between the 2 i believe.. which doesn't matter if you dave f mod them. also, floats will not swap.  beyond that, you can swap allt he 350 stuff in including the hi or low top slide & cap, etc.

yup. glad you caught it.

and, welcome to the board.

reach out to vitos, they can probably do a drop-in crank 4mm stroked

cyl spacing IS the same center to center. you can get a stroker rd crank done though

too wide.

https://www.2strokeworld.net/forum/index.php?board=30.0

yup. sounds like you got it.        

somebody is more than welcome to start a thread. I can create a sub section if need be

Nice!

could also run a pair of crossover up pipes though there 

ooh. high pipes, bleed silencer style (side) with mufflers aimed down and back.

a very 'dog in the manger' attitude. 

thanks wade!. the zip tie on the bar actually bothers me. (old man mode engaged)

I have an idea.....

i mean, that sucks but also fuck them for pitching the moulds into the dumpster, that was a shitty move.

I haven't bought anything from airtech in many years, glass from the past has been my go-to.