Loctite For Injection Nozzles

[IICYCLE]

 Looking for type of locktite to seal injection nozzles. I've done a search but could not find it.

Thanks

[thatguy]

I used Loctite 609 with 7471 primer. Clean well and be quick though.

[Striker1423]

Safety wire them in. You dont need to glue them.  Once glued, twice screwed.

[rodneya]

For the injection nozzles going into the carb, I remember reading online to use a small amount of rubber contact cement.
I used Yamabond on one of mine that was loose.

[SoCal250]

See Tech Bulletin #M4-009
THE TECH LIBRARY »Yamaha Factory Specs and Info »Yamaha Technical Bulletins

[rodneya]

See Tech Bulletin #M4-009
THE TECH LIBRARY »Yamaha Factory Specs and Info »Yamaha Technical Bulletins

So my memory is actually still working a bit. Good to know

[SUPERTUNE]

Loctite green sleeve retainer #640
Chuck

https://www.emisupply.com/catalog/loctite-37424-sleeve-retainer-high-strength-tube-p-14298.html?utm_source=googprod&utm_medium=product_search&utm_campaign=google-product-search-us-en&utm_term=LOC-37424&gclid=Cj0KCQjwm9D0BRCMARIsAIfvfIY7laUqpZj6yCfVrnmmszTlkEMWa7xbr76m3nymfy94qV2Gi5qgOoUaAjkaEALw_wcB#.XpU31VVKjp8

[IICYCLE]

Thanks for all the suggestions. Im going with the the #640,it looks like the right application.

Thanks

[SUPERTUNE]

I've been doing that for 25 years that way...never had one fall out afterwards.  And still on my huge 50ml bottle.

Here's the spec sheet and the reason so expensive, $55 a big bottle.
Chuck

http://media.hiscoinc.com/Volume2/d110001/medias/docus/205/Loctite%20Corporation-30769_135520-TDS_VD.pdf

[IICYCLE]

I've been doing that for 25 years that way...never had one fall out afterwards.  And still on my huge 50ml bottle.

Here's the spec sheet and the reason so expensive, $55 a big bottle.
Chuck

http://media.hiscoinc.com/Volume2/d110001/medias/docus/205/Loctite%20Corporation-30769_135520-TDS_VD.pdf

Thanks for your help

[2steve]

Since carb tuning is still going on after the update porting by Chuck, I'm just doing the zip ties.  So far, so good: