Cover holds the barrel in, carefully pry out the pressed in rivet. Take your time and it'll come out without trashing the cover. The barrel will then come out, and you'll find a spring behind that.
Easy peasy!
Easy peasy!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: Greaser Greg on April 26, 2019, 10:22:42 AM
The manual I have calls it the needle bearing on the end of trans main axle. The clutch pushrods goes through it.
I'd post a picture, but iPad photo res is to high.
Quote from: Organicjedi on April 16, 2019, 12:12:25 PM
The yambits stuff is good. Some of the rubbers seemed a little big. I had to trim the battery box rubbers on my 400 to fit for example.
Their prices were good and they were good quality.
Quote from: Organicjedi on February 28, 2019, 03:34:29 PMThanks Jedi.
The bike is looking clean. Nice job!
Page created in 3.319 seconds with 10 queries.