Messages

Sorry I saw posts saying Gary was making pipes. I didn't see any contact info. Anyone have a number etc.. Thanks

Hello, Just got a small 5x8 enclosed trailer. Pretty sure I can get two RD's inside. Anyone know of a brand of wheel chocks that will fit the narrow front tire. Also just an overall good product. I'm okay if I have to secure it to the floor. I'm sure there are 100 companies out there but I thought someone here could tell me the exact brand they have, have used, or have seen in use. Thank You!!

Hi. Anyone know of an anodizing service that could do my DG heads. They are for my Daytona. My stock Daytona head is fine but needs cleaning/ polishing. I just figure when I sell the bike it needs to look good with either set of  head/heads. They have been cut an o ringed by Scott C. Any help with this service appreciated.

Hello. How much should I expect to pay for a new set of MC rearsets for 79' Daytona? I posted this in the for sale category. My mistake.

The lower fork legs on my 79' Daytona had the obvious clear coat issue from age. Luckily I found some NOS ones. I'd like to recoup some cash by selling the originals. I have use of a soda blaster to strip the old clear coat. Should I try to re-clear or sell them just bare aluminum and let new owner do what they want. Thank You

The MC rearsets are new. Gotta throw that out in case I can't find chambers. Would be ok with a nice used set .

Hello. Who sells 79 Daytona chambers? I have a nice set of JR chambers that utilize the stock header pipes. My problem is I want to put on a set of MC rearsets I picked up a while back but they won't fit with the setup I have. It's either sell the rearsets or buy pipes that they can be used with. Thanks.

Hi guys. Is the Rick's reg/rec. an easy install on a 75 RD350? Sorry if this has been addressed before. This has got to be a good upgrade. Any advice or tips. Thank You.

Hi I use a Mr. Heater overhead propane unit. Think it's 70,000 btu's . Hot Dawg is another brand. They need the double walled pipe to be vented outside but my actual heater was 5 or 6 hundred dollars. I just have a snowman propane tank behind my garage. Northern Tool sells the Mr. Heater and I have had it 8 years no issues.

Hi. Any idea what a new 1.85 Takasago rear rim should go for? The one I'm after is new but needs lacing. I have the OEM spokes. Hard to put a price on them I think. I have never laced one but with today's media I think I could get help. Thank You.

Hello. A lot of info on aftermarket rims. I would like to lace an OEM 1.85 rear rim for 75 350. I am not against paying for this but would try it myself over the winter in NH. Any suggestions or tutorials on this .I am using a new Yamaha rim and spokes. Fortunate to find both.

Thanks guys. Pipes on 400 are J&R. Found them brand new 300$. Those and a one size main jet change seemed to take the stumble around 4500 minimal.

My 75 and 79. Not mint but pretty good!

Hello. I was wondering if anyone on the forum is in NH or knows  someone up here who works on RD's. I have a guy who works on my bikes but is very busy. Thank You!!

Turns out that single slot just need a big flat head screwdriver. It was actually a big plastic screw that held on a cover piece. My helmet is probably older. Thank You!