Mocking up boards, trying to get the spacing right. Looks like adding a couple of 2x8s will get me there, with 8mm spaces between boards.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: m in sc on April 25, 2024, 10:30:46 AMtrying to avoid the 2 screws to pull the needle? i mean, how many times you planning on pulling the needle? tims right, cables are different. to speed thing sup, while tuning, just run 1 screw till its dialed in, then when it sonde, put the 2nd screw in. I do this w fuel bowls as well. 2 screws to tune, 4 for running.
Page created in 0.393 seconds with 13 queries.