What size bolt to remove Iggy rotor from crank?

[Brad-Man]

Subject line says it all...

Bolt size/thread.

Thanks

[m in sc]

M10X1.25

the one from the stock exhaust hanger will work. at least 35mm long total is safe

[Brad-Man]

Thanks Mark!

[~JM~]

Think I used one of the motor mount bolts, some grease & impact gun.

[Jspooner]

Think I used one of the motor mount bolts, some grease & impact gun.

[m in sc]

yup, the rear mount top case bigger bolt. 

[Dvsrd]

yup, the rear mount top case bigger bolt. 

As long as it is M10x1.25.  A previous owner may have replaced it with a more common M10x1.50  (I did once..... ) or worse, a 3/8 bolt (oh, the horror.........)

[pdxjim]

Impact is a little brutal ...

Wind the bolt in tight and give it a sharp whack with a hammer, wind it in a bit more and give it another whack and it'll pop loose.