3d modeled R5/DS7 badge (initial)

[m in sc]

Thanks to Czakky for getting me this set of badges for an r5 tank, i -finally- got it modelled. I can now flip the letters over and make a specific left and right badge. its drawn with the correct tank curve, and the letters recessed into the back as an original. should be able to 3d print in clear, paint, and have much more faithful reproductions than those 'sticker' ones . I will get one test printed at low res for test fitment and see where it goes. 





from the back. it even has the screw boss off the hole to space it out right.



that compound tank curve -sucked- to get right

[Czakky]

 

[dgorms]

Looking good, sign me up for a few..............................D

[m in sc]

as an fyi, im not going to sell any as i have to go elsewhere to get them printed. however, i'll share the file when its finalised.

[quocle603]

I can do a test print for you once you upload the file. I just sold my tank at rice o rama.