Messages

 Used 2 dental tools pulled seal out and replaced. Thanks for the help.
but neutral assembly plate broken . will start a new post

 Thanks for the help. Should be home Saturday. Firing up the pit and working on the RD. Hope I don't rip the gasket to the gen cover. Is there a good gasket source for discontinued gaskets?

Thanks, Bubba

 I have both tools and JIS bits for the impact. I'm guessing it is as simple as removing the gear shifters and screws ? And everything comes off. Fingers are crossed.
Thank You , Bubba

 I've had good luck with Metal Rescue corrosion cleaner. Water base works great in ultra sonic cleaner. Won't flash no fumes to speak of

 Need to remove the left crank case cover to replace gear shift rod seal. Is there a gasket between the cover and the engine? Do  I need to remove the generator cover also? Any tips would be very helpful.
Any secrets to replacing the seal? I have broken a screw on the right side cover screw before . I bought a Soto Pocket Torch. figured I would try and heat each screw before removing.
Thanks for any help suggestions. I work offshore and hopeing to get this done when I get off. Trying  to get the bike ready for the Harvest Classic Vintage Festival in Lukenbauch this October. Lots of nice lookin bikes were there last year.

As Always,  Thanks Bubba