Print Page - Jetting Baseline VM32's

Title: Jetting Baseline VM32's
Post by: Economy Cycle John on May 02, 2019, 01:42:48 PM

Anyone have a good baseline jetting for VM32's on a 350?

Title: Re: Jetting Baseline VM32's
Post by: SUPERTUNE on May 02, 2019, 03:34:11 PM

Been a long time I did VM32's.

Ported cylinders, UPP manifolds w/ crossover, DG pipes, 1.9mm timing, cut cylinders for 400 headgaskets, uni filters, tdr reeds.
3.0 slides, 6DH3-2, 159-P6, 42.5 pilot 310 mains, 2.0 airjet.

Chuck

Title: Re: Jetting Baseline VM32's
Post by: Economy Cycle John on May 02, 2019, 03:48:09 PM

Thanks very much Chuck!

Title: Re: Jetting Baseline VM32's
Post by: Tuck on May 02, 2019, 03:51:25 PM

I know your asking for a 350, but just thought I would throw this out there... I was using vm32 before I got the TM34's (Thank you Chuck). Jetting I ended up with was, 320 main, 45 pilot, 159-P2, 6DH3, 2.5 slide. :twocents:

Title: Re: Jetting Baseline VM32's
Post by: Economy Cycle John on May 02, 2019, 04:35:23 PM

Quote from: Tuck on May 02, 2019, 03:51:25 PM
I know your asking for a 350, but just thought I would throw this out there... I was using vm32 before I got the TM34's (Thank you Chuck). Jetting I ended up with was, 320 main, 45 pilot, 159-P2, 6DH3, 2.5 slide. :twocents:

Thanks Tuck, very helpful
John

2 STROKE WORLD .net

The 2-Stroke Garage => Turning Wrenches => Topic started by: Economy Cycle John on May 02, 2019, 01:42:48 PM