Little update. Working on new pump coupler set up and probably starting the frame that will hold the pump and load cell. Built something to funnel the exhaust outside. Works extremely good.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: rd400canuck on January 11, 2022, 05:09:10 PM
Well... welded the frane up really well and had another run and bad news. Around 1200 psi and at aroind 2000 rpm it took the frame and twisted like a pretzel. I think im gonna have to build and engine cradle out of square steel tube to hold the motor out of the bike and do it that way. There just isnt enough room for a beefier pump mount between the swingarm. I feel a little deflated..its turning into a far bigger job than i anticipated.
Quote from: sav0r on December 22, 2021, 01:43:30 PM
Aliexpress is always an adventure. I avoid it, but sometimes I get tempted.
Quote from: m in sc on December 14, 2021, 11:29:03 AM
It'll do it. Not me. But send it down i have stainless wire i'll tig it up.
Quote from: m in sc on December 13, 2021, 11:24:29 PM
it'll do it.
Page created in 0.273 seconds with 11 queries.