Which 400 cyl's are best for porting ?
1A1's or 2V0"s ?
1A1's or 2V0"s ?
- Welcome to 2 STROKE WORLD .net.
2 STROKE WORLD
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Turning Wrenches / RZ & Banshee Intake Boots
December 28, 2020, 04:14:23 PM
Hi & Merry Christmas.
Will 34mm carbs fit the RZ 350 & Banshee stock intake boots ?
I see there are some aftermarket ones that say they fit the larger carbs.
Will 34mm carbs fit the RZ 350 & Banshee stock intake boots ?
I see there are some aftermarket ones that say they fit the larger carbs.
#3
Haus of Projects / Daytona Project
November 22, 2019, 05:24:02 PM
New Member with a long overdue project. The last time I rode it was 1986, then it sat, then it was stolen in 2014 then recovered in 2016 and sat till now. I have been collecting odds & ends for it since it was recovered, so I think over the winter I am going to go thru it.
Bike Specs: It's a Tom Turner build with a heavily ported 434cc big bore kit, with I believe either TZ or RZ reeds with 34mm Mikuni's and I assume their his Chambers. I parked it in 86 after I picked up an RZ, but that's another story.
When it was parked it ran beautifully no issues but because of the time it sat the engine will need all new seals to start with, and I should have the crank checked out, so I have been checking around to see who's available and does good work.
Any suggestions would be appreciated.
Bike Specs: It's a Tom Turner build with a heavily ported 434cc big bore kit, with I believe either TZ or RZ reeds with 34mm Mikuni's and I assume their his Chambers. I parked it in 86 after I picked up an RZ, but that's another story.
When it was parked it ran beautifully no issues but because of the time it sat the engine will need all new seals to start with, and I should have the crank checked out, so I have been checking around to see who's available and does good work.
Any suggestions would be appreciated.
Pages1