Messages

Ssme question here...

Been in a get rid of shit mode and found a couple of his ignitions. Anyone have  any good things to say about them after all these yrs? Any value?  1 is nib. I'd like to offer them  here perhaps.

I've seen DC voltage regulators
Seems like what I would like for my application

This is where I get confused. Floating grounds, 2 legs?

I'm  installing one of these on a bare minimum type bike. Led Head, tail and brake light and acewell gage. All seem to be dc voltage. Can I just use a regulator of some type on yellow wire before a fuse block and no battery? I'm  not great with electrics, thanks

I figured it out they sent me the wrong one

Anyone know if the calipers sold as aluminum have a funky banjo bolt size like 3/8? I tried 2 10mm ones so far and no go

Thanks, just thinking  of using the ninja motor in  a big tired minibike bike.

Can anyone here that might of put an rd  engine into a 250 ninja give me a close height dimension of the kaw motor?   Contemplating a minibike swap.  Thanks

I'm hoping s,  2.15" x 19" mikes wheel and spokes fit rd hub. Triple trees with a dirt track type tire on it.

Short and sweet. Are the 36 spoke 650 hubs the same as rd350's? I'm  looking at buying a 19" rim and spokes from Mike's.  Can't afford the good ones!

mcnichols plating in the detroit area can do it

Yep. that's what I have in mind.   or a careful measurement!  yrs ago I'd have learned it the hard way too!

 any of you guys remove the big crossmember on bottom when de-tabbing?  My plan its to take it out and add a plain cross tube just in front of it. That way I think I can move kickstand forward to clear pipes better too. I've heard comparable year TZ's had nothing at all there so I'm not too concerned. Any thoughts?

Any of you guys up on the monoshock vs twin shock differences?  Short version is I have a Monoshock engine I want to put in a twin shock frame. I believe the engines are completly different and don't have the chassis yet.  Somewhere I read where rear motor mounts are the same and that would be awesome - I could deal with the rest.  Any thoughts or maybe someone knows someone?