Messages

I have the Delkivic pipe on my kz650,quality and workmanship are first class, oh and the weight savings is great also.

The kz650 sounds sweet with the Delkivic pipe , especially when the revs start to climb.  I like it.   Looks great

here ya go one brake rotor pic. I can measure the inner diameter later today if needed.

ran across this info also.http://www.ksrc-au.com/phpBB3/viewtopic.php?f=31&t=17834

mag is from 77 kz1000 z1-r. Hope this helps. I also have the stock rotor if that would help.

early kz1000 and kz650 share the same 4 bolt pattern. what happened ?   sorry I hate when that happens. I swapped  z1r rotors to my 77kz650.

yeah. I would like to see that..

nice looking progress, is that the stock front caliper? here are some pics of my set of gauges, I have the idiot light cover also. I think what you have looks better than what I have. They do function.

I will snap a few, mine are faded some also, sorry.

Mark, I have a set that I do not need. If you are interested I can send some pics.  Cheap.   Basically postage

What kinda of gauges or gauge are you gonna use? Aka tach,speedo.

Pirelli mt75 on my rd and Dunlap 404 on my kz650.

new toy is tail section and upholstery. Wade... you win. its a 120 Pirelli very slight chain misalignment but has not been an issue in place and not fussing been in place for a while not exactly sure of milage but has not been enough to warrant my snagging a offset sprocket..oh these are 16" wheels so far handling has been good, part of it might be having a wider up right handlebar has help control the steering quickness, I have made adjustments to bring trail closer to stock. Bike has seen about 85mph in current configuration without any unwanted evil feedback.i still may do a swap to 17" wheel and tire combo, just not yet. I want to get more details ironed out

I need to pull them out and do some checking.

I
 have a set off a MK2 with pump  may give these a kit then on the 650