TZ750 frame fabrication

[mavguy]

A friend of mine who is a machinist and me were planning on fabricating a TZ750  frame from scratch
Any help with Regards to dimensions, measurements and blueprints would be welcome .thanks.

[m in sc]

are you a fabricator? If not, thats what you need. might want to reach out to Danny (27cycles). for some insight on process.  as far as dimensions,  Ive seen them out there but its been a LONG time. also depends what model tz. Might want to reach out to barbers in Alabama, they have a stack of tz750s and they have a LOT of documentation.

[85RZwade]

NATS forum would be a good resource, also. Guys like Rusty Bigley there who have been racing those glorious machines for decades.