I would try going the other way with the needle clip and lean it out.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: Hemi on April 14, 2024, 01:10:59 PMJspooner,
I've checked several parts diagrams and I don't see the springs you noted at the bottom of the forks?
I can't seem to paste a photo here.
Hemi
Quote from: Jspooner on April 13, 2024, 02:42:46 PMIt's not the dampening rod. Can't really do anything wrong there. What I'm talking about are actually at the bottom of the tube on the inside. If you pull it all apart and remove the dampening rod and look at the bottom of the tube you'll see s9me stuff held in with come c-clips. That's what I'm talking about. Normally you leave that stuff in tact when working on the forks but when you replace tubes you have to remove then and reinstall them in the new tubes.
Page created in 0.115 seconds with 9 queries.